These wireless systems are fully expandable up to 4 sensors to the one receiver. You can have any combination of the type of sensors.
Note that while we say an 800m range, it does depend on the environment and if there are any obstacles that could obstruct direct line of sight.
We stock long range wireless driveway alert kits that have been specifically designed for DIY in mind. You can install them easily yourself without any technical knowledge or specialist tools. The kits run on batteries which generally last for 6 months. And best of all - there is no cabling. Put up the sensor, plug in the receiver and you are pretty much ready to go.
DRIVEWAY ALERTS
DRIVEWAY ALERT KIT EXPANDABLE up to 4 sensors
Outdoor Probe Driveway Alert Kit (DCPA-2500)
Outdoor Motion Alarm Kit (DCMA-2500)
This alert kit is used to detect vehicles only. The battery powered transmitter has 15m of direct burial wire connecting the probe to the exterior case. Burying the probe parallel to the driveway, it will detect vehicles passing within approximately 3.5m. The burial wire can be run to a tree or post nearby where the transmitter box can be mounted. The transmitter will send a signal to the receiver (usually placed in the house) up to 800m away (actual range is dependant on the environment.)
The receiver can connect to up to 4 sensors and is programmable to play different alert sounds allowing you to distinguish between different areas. The receiver also offers a 5 minute exit delay so that you can leave the house without disturbing sleeping occupants.
Operating Range: -35 to 50 degrees celsius
This alarm kit senses motion. The battery powered sensor will detect motion (human, animal, vehicle) up to approximately 15m. The sensor will send a signal to the receiver (usually placed in the house) up to 800m away (actual range is dependant on the environment.)
The receiver can connect to up to 4 sensors and is programmable to play different alert sounds allowing you to distinguish between different areas. The receiver also offers a 5 minute exit delay so that you can leave the house without disturbing sleeping occupants.
Operating Range: -35 to 50 degrees celsius
Point to Point Beam Kit (BBA-2500)
The Point to Point Beam kit is a solar powered Infra-red Break Beam system that is simple to install and requires to wiring. The Break Beam sensors are powered by Lithium Ion batteries that are recharged through the solar panels during the day. The Beam Sensors can be mounted up to 80m apart and as someone passes between them, the sensors will send a signal to the receiver (usually placed in the house) up to 800m away (actual range is dependant on the environment.)
The receiver can connect to up to 4 sensors and is programmable to play different alert sounds allowing you to distinguish between different areas. The reciever also offers a 5 minute exit delay so that you can leave the house without disturbing sleeping occupants.
Operating Range: -35 to 50 degrees celsius
Portable Pocket Receiver (PR-2500)
The Portable Pocket Receiver is a pager-like device that is compatible with all our our 2500 series transmitters. The receiver has an LCD display and gives both an audible alert and/or a vibration for when a sensor has detected motion.
It is capable of receiving and storing alert signals from up to 4 sensors. Each sensor can store up to 400 entens with a date/time stamp. The rechargable Li-ion battery within the pocket receiver will hold a charge for up to 10 days (charger included.)
Outdoor Probe (PA-2500)
Additional outdoor probe units are available to extend an existing alert kit. Can be added to the DCMA-2500 - ANZ kit or the DCR-2500 - ANZ receiver.
Outdoor Sensor (MA-2500)
Additional Outdoor Motion Sensor units are available to extend an existing alert kit. Can be added to the DCMA-2500 - ANZ kit or the DCR-2500 - ANZ receiver.
Outdoor Point to Point Beam Set (BB-2500)
Additional Outdoor Point to Point Beam units are available to extend an existing alert kit. Can be added to the DCMA-2500 - ANZ kit or the DCR-2500 - ANZ receiver.
Additional wireless receivers are available to receive signals from up to 4 sensors.
Wireless Receiver (WR-2500)
Need Help Choosing? No problem
Our trained security consultants are here to help you create the right solution for YOUR needs.
Call us today on 0508 036 287
